![]() ![]() Apparently, it updated to the latest version. One thing I didn’t mention was that a new firmware was actually available when I went through this process. Yes, I did check that the hub was set to autodetect new firmware. What you want to do is to select Source, then select Folder, then select the Iron Man folder and then click on Select Folder. ![]() So if say you have ripped Iron Man, with HB you don’t want to select Source, then select Video File, then go into the Stream folder and select the m2ts file. You want to select Source/Folder, because some BD’s have multiple m2ts files that make up the entire movie, although the most are a single m2ts file. With BD50 it doesn’t compress the file so what ever size your movie is, is what the output will be.Īlso, in HB you don’t want to select the m2ts file (don’t use Source/Video file) if your movie is in folder format on you HDD. If you select BD25 and you movie is larger than that, then dvdfab will compress it to fit on that size disc. DVDFab has 2 options, BD25 (for 25GB disc) and BD50 (for 50GB disc). All that setting is for is so that you don’t get a compressed output. The BD50 only means that you can burn to a BD50 disc, not that the file size will be 50GB. This will reset your HUB back to factory defaults and then you should be able to see the “New Firmware” and then you can rollback. If you still don’t see it after that, go to Setup / System / Device Reset. ![]() If you still don’t see it, try unplugging the power cord then plugging it back in. Well, if you’re not seeing New Firmware, make sure that you have the HUB set to auto detect firmware.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |